The best machines for cutting hollow heads are designed so that the saw cuts the material at a small angle.
,The best machines for cutting hollow heads are designed so that the saw cuts the material at a small angle.
The sawing element is most often placed in such machines no more than 10 degrees opposite to the base of the vise, for cutting the harvested material with a saw at an angle, but not parallel to the top of the workpiece.
The process of cutting at an angle gives less stress on the teeth of the band saw.
This moment is most clearly expressed when sawing square pipes that are connected together, when forming a wide plane at the beginning of cutting.
Sawing large or sufficiently wide workpieces requires the motor of the device to work in high load mode.
When cutting with an angle of only 3 degrees, the cutting width is significantly reduced.
An important element is the vise, designed to work with large volumes.
They are designed so that they clamp the material from 2 sides to the cutting line and beyond.
This reduces vibration and the likelihood of seeing burrs on the workpiece after cutting.
09 Martha 2017
